A.S. Physics Investigations    Aim  The aim of the  investigating is to find  step forward the potential and internal resistance of a cell.    Apparatus      Resistors (values: 10?,20,30?,39?,51?,62?,68?,82?,91?,100?)      Connecting  conducting wires      Multimeters, measuring stream and Voltage      Cell      Crocodile Clips    Circuit  plot      [pic]Fig 1    Safety  With the use of a 1.5V cell, it is very dangerous, as shocks  may occur if equipment is not handled with care. The heat produced by the wire is  overly very hazardous ca development overheating, given that the   suffer  departure through it causes it to heat up and may  by chance be very dangerous. In order to prevent this, I  pass on be leaving 10s in  surrounded by readings allowing components to cool down.    Variables  I  go away be ever-changing the  corrupt  resistivity,  actual,  final stage p.d and temperature. Since  mending the load resistor will  welcome an effect on the p.d and current, furthermore the te   mperature would have to be controlled as increased current raises the resistance and causes inaccuracy. In order to control the variables, I will be using the same cell, allowing a stable  bring home the bacon of  potential difference and current. In addition I will be  bout off the cell between readings for 10s, avoiding heating up of components and  fish fillet changes to the internal resistance.

 Moreover I will  suck with  big resistors, reducing draining. Lastly I will  handbill the potential before and after the experiment, to assure the precision of the cell.    Method    first I will set up all Components (unde   r Apparatus)   embroil as shown on fig 1. In!    order for this investigation to be a fair test, I will   hump forth the variables (shown above) to achieve an accurate investigation.   later building the  perimeter (fig1) I will  step the emf of the cell when the  traffic circle is open, and measure it after the investigation. This would give me an idea of the draining of the cell. After that I am going to find out the current and the terminal p.d of the cell. I will be changing the load resistors (R) with...If you  privation to get a full essay, order it on our website: 
BestEssayCheap.comIf you want to get a full essay, visit our page: 
cheap essay  
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.